Jay Electronique Jump Notice D'installation page 53

4.2.3- Configuration of radio transmit power
The Jump repeater can be configured for different radio transmit
power levels.
The radio transmit power setting is defined by the user and is chosen
to limit or adapt the range in accordance with the application and the
desired endurance. It must respect the laws in force in the country
where used.
The average range in open space depends on the environment
conditions, the position of the antenna and the orientation of the
components of the radio remote control system.
The power level is adjusted using the «configuration» DIPswitch, with
cursors No. 1, 2 and 3.
Jump
(«Battery» version shown)
Cursor position table :
Cursor Cursor
nb.1 nb.2
ON ON
OFF ON
ON OFF
OFF OFF
Jump - 332970E_A005
04/03/21
CHARGE
ERROR
LD1
LD5
CONFIG
ERROR
Cursor
nb.3
433 MHz Band
1 <1mW / -5dBm -12dBm
OFF
2
OFF ≈1mW / 0dBm
3
OFF 3,16mW / 5dBm -5dBm
4 10mW / 10dBm -2dBm
OFF
LD4
TENS UNITS LD3
LD2
B
A
CONFIGURATION
Corresponding power level
915 MHz Band
-8dBm
ON
1 2 3
CONFIGURATION
920MHz
Channel 1 to Channel 16
15
-10dBm -15dBm
0dBm -10dBm
7dBm -5dBm
13dBm 0dBm
EN
«ON»
position
«OFF»
Position
cursor
to 31
FR
- 53 -