Cleaning And Storing; Notes On Environmental Protection / Disposal; Ordering Spare Parts; Troubleshooting - EINHELL GE-EC 720 T Mode D'emploi D'origine

Anleitung_GE_EC_720_T_SPK7__ 13.03.13 08:47 Seite 21

9. Cleaning and storing

Regularly clean the clamping mechanism by
blowing it out with compressed air or cleaning it
with a brush. Do not use tools for cleaning.
Keep the handles free of grease so that you can
maintain a firm grip.
Clean the equipment as required with a damp
cloth and, if necessary, mild washing up liquid.
If the chainsaw is not to be used for an extended
period of time then you should remove the chain
oil from the tank. Briefly immerse the saw chain
and the cutter rail in an oil bath and then wrap
them in oil paper.
Important!
Always disconnect the mains plug before
cleaning the chainsaw.
Never immerse the unit in water or other liquids in
order to clean it.
Store the chainsaw in a safe and dry place out of
the reach of children.
10. Notes on environmental
protection / disposal
The equipment must be properly disposed of when it
reaches the end of its service life. Cut off the power
cable to prevent it being used by mistake. The
equipment must not be disposed of as domestic
waste. Instead, in the interests of the environment it
should be disposed of via a designated recycling or
disposal point for electrical equipment. Please contact
your local authorities for information about proper
disposal of the equipment in your area. Packaging
materials and worn accessory parts should also be
disposed of at the designated recycling or disposal
points.

11. Ordering spare parts

Please provide the following information on all orders
for spare parts:
Model/type of the equipment
Article number of the equipment
ID number of the equipment
Part number of the required spare part
For our latest prices and information please go to
www.isc-gmbh.info

12. Troubleshooting

Caution!
Before troubleshooting, switch off the equipment and
disconnect the mains plug.
The table below contains a list of fault symptoms and
explains what you can do to remedy the problem if
your equipment fails to work properly. If the problem
still persists after working through the list then please
contact your nearest service workshop.
GB
21