PRO-POINT 8569741 Manuel De L'utilisateur page 18

V1.0
Air Die Grinder
8569741
4. Oiling your air tool regularly is important, but also is
important not to OVER oil your air tool. Over oiling
can cause premature tool failure. Your tool may not
be ruined, but it will begin to experience loss of
power that will continually get worse until it no
longer works. The tool then has to be taken apart
and cleaned of excess oil.
5. All air tools are packed in grease to prevent
corrosion of internal parts during shipping and
storage. We recommend that you clean this out to
have optimum performance from your new air tool.
Use two drops of air tool oil to lubricate the tool
and run the tool under no load until exhaust is clear.
6. In the event that it becomes necessary to store the
tool for an extended period of time (overnight,
weekend, etc.), it should receive a generous amount
of lubrication at that time. The tool should be run
for approximately 30 seconds to ensure oil has
been evenly distributed throughout the tool. The
tool should be stored in a clean and
dry environment.
CAUTION! Do not at any time allow brake fluids,
gasoline, petroleum-based products, penetrating oils,
etc. to come in contact with plastic parts. They contain
chemicals that can damage, weaken or destroy plastic.
STORAGE
When not in use for an extended period, apply a thin coat
of lubricant to the steel parts to avoid rust. Remove the
lubricant before using the tool again. Keep this tool and
its accessories in a clean, dry location and out of the
reach of children.
Visit www.princessauto.com for more information
17