PRO-POINT 8569741 Manuel De L'utilisateur page 13

8569741 Air Die Grinder V1.0
USE AND CARE OF THE TOOL
1. Use the correct tool for the job. This tool was
designed for a specific function. Do not modify or
alter this tool or use it for an unintended purpose.
2. Do not carry the tool with fingers near or on the
trigger /switch.
3. Avoid unintentional starts. Be sure that the
regulator /throttle switch is in the neutral or OFF
position when not in use and before connecting it
to any air source.
4. Remove adjusting keys and wrenches from the tool
before operation or connecting it to a power
source. A wrench or key that is left attached to a
rotating part of the tool increases the risk of
personal injury.
5. Conduct regular maintenance according to the
schedule found in the Maintenance section.
INSTALLING AIR QUICK COUPLER
Prepare a standard 1/4 in. NPT male air quick coupler for
use with your tool.
1. Wrap the external threads of the male quick
coupler with sealant tape.
a. Wrap the tape in a clockwise direction so it
will not unravel.
b. Do not tape all the threads. Leave several
leading threads unwrapped for
easier alignment.
2. Screw the quick coupler into the tool's air inlet and
tighten with a wrench until snug.
12
For technical questions call 1-800-665-8685