PRO-POINT 8569741 Manuel De L'utilisateur page 14

V1.0
Air Die Grinder
8569741
3. Run the compressor at a low volume and check the
connection for air leaks. Do not use the tool until all
air leaks are repaired or the faulty component
is replaced.
UNPACKING
1. Carefully remove the tool from the package.
a. Retain the packing material until you have
carefully inspected and satisfactorily installed
or operated the tool.
2. Inspect the parts carefully to make sure the tool
was not damaged while shipping.
OPERATION
WARNING! Hand, wrist and arm injury may result from
repetitive work motion and overexposure to vibration.
WARNING! Disconnect the tool from its air supply
before changing accessories, servicing or
performing maintenance.
1. Select the appropriate accessory for the task. Only
use stone which are specifically designed for use
with the die grinder. Make sure they are capable of
handling the tool's maximum speed of 22,000 RPM.
Make sure the accessory is tightly installed.
2. Attach the accessory to the grinder.
a. Push the spanner in the collet shaft.
b. Inserting mandrel a minimum of 1/4 in. into
collet chuck minimizes vibration, delivers
better results, and reduces the risk of injury
CAUTION! Inserting, into collet chuck a minimum of 1/4
in. to prevent wheel or file from disengaging with
grinder while in use.
Visit www.princessauto.com for more information
13