Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Turn the adjusting wheel until the desired program step is shown in the display.
Press the adjusting wheel to change the desired program step.
Turn the adjusting wheel until the desired program command is shown in the display.
Press the adjusting wheel to accept the selected program command.
Some commands require the additional selection of a corresponding parameter. If, e.g., the
command "Motor rechts drehen (right-hand rotation of motor)" is selected, it is also required
to enter the speed.
By pressing the
cancellation key a process can be terminated at any time and you will enter into
the next (higher) control level.
The commands that can be selected and the corresponding parameters:
No
Command
0
End
1
Wait
(maintain current status)
2
Wait for key
3
Wait for vacuum
4
Set vacuum
without waiting
5
Right-hand rotation of motor
6
Left-hand rotation of motor
7
Output
8
Presetting vacuum
9
Presetting speed
10
Presetting direction of rotation
11
Presetting stirring time
12
No action
To facilitate the creation of programs a Windows
accessory.
3.4 Program names
In this area the names of the stored programs can be changed.
Go to the "programming" operation mode (see section 3.1)
Select the "program names" area.
26
Name
Parameter
End
-
Wait
Time in sec (0..255)
Wkey
0 = "continue ?"
1..15 =text number of own texts
16 = acoustic signal key stroke
17 = acoustic signal program end
18 = acoustic signal error message
19 = acoustic signal speed sensor
20 = blank line
Wvac
Vacuum in % (0..100)
Vacu
Vacuum in % (0..100)
Right
Speed in rpm (0,100..600)
Left
Speed in rpm (0,100..600)
Outpu
0 = default text with time bar
1..20 see "wait for key"
Pvac
Vacuum in % (0..100)
Pspee
Speed in rpm (0,100..600)
Pdire
0=left-hand, 1=right-hand rotation
Ptime
Time in seconds (0..240)
Blank
-
®
PC program (REF 5314 0102) is available as
Publicité
Table des Matières
