Starting Of Stirring Programs - DeguDent Multivac compact Mode D'emploi

Press the adjusting wheel to accept the value as a presetting.
The changed value is now accepted in the lower line of the display.
Couple in the mixing bowl.
Start the vacuum pump.
In the display a progress bar can be seen which indicates the current vacuum value. The
vacuum is adjusted to the set value. The current vacuum is indicated in the lower display line.
.
Start the stirring mechanism.
In the display a progress bar can be seen which indicates the stirring time that has already
run down. The current vacuum is indicated in the lower display line. During the progress, the
stirring mechanism and the vacuum can be switched off or on at any time without influencing
the chronological progress.
The stirring process can be interrupted at any time by pressing the cancellation key
After the set stirring time has expired, an acoustic signal can be heard. The stirring
process is stopped and the mixing bowl is ventilated automatically.
Press the unlatching button of the bowl support and bring the bowl support into the
lower position again.
The adjusted values are set back to the standard values after each stirring process.
If - during evacuating - a leak is found in the system, a warning signal can be heard and the
displayed vacuum value is marked with an asterisk.

2.4 Starting of stirring programs

Switch on the unit.
Select a preset program.
The stored program name is shown in the display. The program selection can be changed by
pressing a different program key or by turning the adjusting wheel.
Couple in the mixing bowl.
Start the mixing program.
Depending on the program progress bar messages are shown in the display. The lower
display line shows the current settings. The stirring process can be interrupted at any time by
pressing the function key
The stirring process is stopped and the mixing bowl is ventilated automatically. After the end
of stirring program an acoustic signal can be heard.
.
.
23