Dishwasher Setup - Gaggenau DF 260 Notice D'utilisation

Dishwasher setup

•
Water softening system
The dishwasher requires soft water to ensure proper washing results.
Your appliance is equipped with an internal water softening system.
However, if you have a household water softening system, you will not
need to use this softening system.
The required amount of salt depends on the degree of hardness of your
tap water (See table for more information).
For the water softening system to function properly, it will need to use
dishwasher water softener salt .The amount of salt dispensed can be set
from "H:00" to " H:07". Salt is not required at H:00 (this is the default
factory setting).
• Open the door.
• Turn the unit on using the ON/OFF button .
• Hold down the "A" button and press START button until the display
indicates "H:00".
• Release both buttons.
• Press "B" to select the desired setting.
To change the setting,
• Press "C" button .
• Save the selected language by pressing the START button.
• Close the door.
Using a water hardness test strip
The strip will be included in the detergent sample kit
Dip briefly the test strip into tap water for one
second, shake off excess water compare after 1
min.
6
tap
water hardness
ppm CaCO³/l
0 - 110
120 - 140
150 - 180
190 - 210
220 - 290
300 - 370
380 - 540
550 - 890
Default setting from factory is H:00
SAMPLE TEST STRIP
Establishing the water
hardness
After one minute the red
dicoloration of the test
areas will show you the
correct setting.
0
1
2
3
4
set value
at
dishwasher salt
H:00
H:01
H:02
H:03
H:04
H:05
H:06
H:07
Setting of
Water Fill with Salt
Alignment of
Softening Fill salt into the salt
Unit container
0 no
0 no
2 yes
4 yes
6 yes
use
regeneration
no
yes
yes
yes
yes
yes
yes
yes