Accessories - DeWalt DW7440RS Guide D'utilisation

K
L
F
3. Repeat with the other end of the stand.
4. Pull the extendable handle (K) out of the side of the stand. The
spring-loaded handle lock (L) will lock the handle into position for
transporting the saw on the stand. Pull the handle lock down to
release the handle and then slide the handle in for storage.
WARNING: To reduce the risk of personal injury, DO NOT
operate the table saw mounted to the stand with the legs folded and
the stand sitting on the ground.
WARNING: To reduce the risk of personal injury, DO NOT attempt
to store the stand – with or without the saw attached – in a vertical
position. Loss of control may result.
To Raise Stand from Collapsed Position
Roll the stand to the workspace. Be sure the area is flat and stable
before attempting to set up the saw and stand.
1. Tilt up the stand until the saw is at a 45 degree angle.
2. Depress the leg release levers one at a time to release the
locking pins and pull the front legs out until each locking pin
clicks into the detent.
WARNING: Be sure that the locking pins have engaged and
the legs are firmly held in place.
3. Rest the stand on the legs.
4. Depress the handle lock to release the handle. Slide the handle
into the leg support for storage as you work.
5. Go to the opposite side of the stand and grasp the saw under the
rear axle. Lift the saw and stand.
6. Reach under the stand and, one at a time, depress the leg
release levers to release the locking pins. Pull out the remaining
two legs. Be sure that the locking pins have engaged and the
legs are firmly held in place. Rest the stand on the ground.

Accessories

WARNING: Since accessories, other than those offered by
D WALT, have not been tested with this product, use of such
E
accessories with this tool could be hazardous. To reduce the risk of
serious injury, place stand on flat, stable surface. DO NOT create
unstable conditions.
Recommended accessories for use with your tool are available at
extra cost from your local dealer or authorized service center. If you
need assistance in locating any accessory, please contact D
Industrial Tool Co., 701 East Joppa Road, Baltimore, MD 21286,
call 1-800-4-D WALT (1-800-433-9258) or visit our website www.
E
dewalt.com.
Repairs
To assure product SAFETY and RELIABILITY, repairs, maintenance
and adjustments should be performed by a D
center, a D WALT authorized service center or other qualified
E
service personnel. Always use identical replacement parts.
Three Year Limited Warranty
D WALT will repair, without charge, any defects due to faulty
E
materials or workmanship for three years from the date of purchase.
This warranty does not cover part failure due to normal wear or tool
abuse. For further detail of warranty coverage and warranty repair
information, visit www.dewalt.com or call 1-800-4-D
433-9258). This warranty does not apply to accessories or damage
caused where repairs have been made or attempted by others. This
6
WALT
E
WALT factory service
E
WALT (1-800-
E