DeWalt DW7440RS Guide D'utilisation page 3

DW7440RS Rolling Table Saw Stand
with Folding Legs
WARNING: For your own safety, read the table saw instruction
manual before using any accessory. Failure to heed these warnings
may result in personal injury and serious damage to the table saw
and the accessory. When servicing this tool, use only identical
replacement parts.
This stand is designed for use with table saws only and may be used
for most portable table saws. If you have any problem with alignment
or mounting, please call 1-800-4-D
Tools Required
Phillips screwdriver
Socket or wrench set
Contents
Stand Carriage head bolts (2)
Mounting brackets (2) M8 lock nuts (4)
Wheels (2) Rear axle
Rubber bumpers (2) M4 screws (2)
Washers (4) M4 lock nuts (2)
Saw mounting hardware: hex head bolts (4), washers (8),
nuts (4), lock washers (4)
General Safety Instructions for Table
Saw Accessories
WARNING: To reduce the risk of personal injury:
• ALWAYS use eye protection. All users and bystanders must
wear eye protection that conforms to ANSI Z87.1.
• Ensure all stand fasteners are securely fastened and that all
stand mechanisms are in proper working order before operating
the table saw.
WALT (1-800-433-9258).
E
• DO NOT exceed the weight this stand can hold. The DW7440RS
table saw stand is designed to support 150lbs. (68 kgs.) safely
in a work environment. It is unsafe to climb, sit or stand on the
stand.
• Follow the mounting instructions carefully. Fasten the tool to the
saw mounting brackets securely as instructed.
• DO NOT modify or use stand for operations for which it is
unintended.
• DO NOT use the stand on uneven surfaces. DO NOT use the
stand with the legs folded and stand sitting on the ground. The
stand is designed to be used on a flat, stable surface.
ASSEMBLY
Attaching the Wheels and Axle
1. Attach the axle (A)
to the leg support (B)
by aligning the pre-
drilled holes. Ensure
the long end of the
axle is to the rear of
the stand as shown.
A
Secure axle to
leg support using
two carriage bolts,
washers and lock
nuts provided.
2. Place the wheels
(C) on the axle and
secure with washers
and lock nuts
as shown. Tighten
wheel and axle nuts
securely.
2
B