Publicité
Les langues disponibles
Les langues disponibles
Time setting
Pull out the crown to position 2. This will stop the move-
ment. To set the time accurately to the second, it is best to
stop the movement as the seconds hand passes 60. Now
move the minute hand a few minute strokes beyond the
time to be set. Then position the minute hand by moving it
gently backwards until it is exactly above the correct
minute stroke. This ensures that the minute hand begins
to move immediately when you restart the movement. To
start the seconds hand, push in the crown to position 0.
When setting the time, please be aware of the date
change, which always takes place at 12 midnight. If this
change has already taken place at 12 noon, you must
move the hands forwards by 12 hours.
Important: Although the watch is water-resistant in pos-
itions 0, 1 and 2, the crown should always be screwed in
again for normal use (position X).
Reading the time in the dark
The dial, the hour and minute hands, as well as the
marking on the rotating bezel of your watch have lumi-
nescent elements that allow you to read the time effort-
lessly, even in total darkness. The two luminescent elem-
ents at 12 o'clock serve as a reference point.
Publicité
