Scheppach PL285 Traduction Du Manuel D'utilisation Original page 20

GB
• Change saw blade and fix them in reverse order
• Attention: The saw blade continues to rotate after
the machine is switched off.
13. MAINTENANCE
Don't clean or do maintenance on the machine whi-
le it is still connected to the power supply.
The machine requires little maintenance and contains
little parts that must undergo the operator of a service.
Faults or defects that may affect the safety of the ma-
chine must be rectified immediately.
Notice:
Clean your machine regularly after every usage – it
prolongs the machines lifespan and is a pre-requi-
site for a safe working environment.
Repair jobs shall be performed by respectively
trained professionals only!
• Check regularly the condition of the security stickers.
Replace them if required.
• Check regularly the condition of the saw band and
the saw band guide.
• The good condition and perfect adjustment of the
guiding rollers is essential for a smooth band gui-
dance and a clean cut.
• Store the machine in a closed, dry location.
14. Trouble Shooting
Trouble Possible cause
Machine stops or will On/OFF-switch damaged
not start
Saw unplugged
Overload tripped
Fuse blown on circuit breaker tripped
Cord damaged
Machine slows down Experting too much pressure to the
during working sanding abrasive
Work piece burns Wrong saw blade
during the working
Too much pressure
process
20 І 56
 www.scheppach.com  service@scheppach.com  +(49)-08223-4002-99  +(49)-08223-4002-58
Maintenance plan
• After each workshift: Remove chips and dust from
the device
• After 10 hours of operation: When working metal it
is possible for conductive dust to settle in the interior
of the power tool. The total insulation of the power
tool can be impaired. Blow out the interior of the po-
wer tool via the ventilation slots with compressed air.
Cleaning
After each workshift the machine has to be cleaned.
Remove chips etc. with a suitable tool. Do not remove
them by hand (cutting injury!). Remove dust as well.
Notice
The usage of certain solutions containing ingre-
dients damaging metal surfaces as well as the
use of scrubbing agents will damage the machine
surface!
Clean the machine surface with a wet cloth soaked
in a mild solution
Solution
Check the switch
Check all power connections
Allow motor to cool and reset by pushing off switch
Change fuse or reset circuit breake
Change cable
Exert less pressure on the work piece
Change saw blade
Reduce pressure