Meec tools 015277 Mode D'emploi page 22

EN
4. Place the product on the bottom of the
tank. Fasten the end of the line securely
when the product is lowered down.
The product can also be used suspended
from the line. The product is ready to use
when it is connected to the power supply.
NOTE:
• The product needs a free space of at least
60 x 60 cm. The maximum submersion
depth is indicated in the technical data.
• Install the product so that the intake
opening cannot be blocked.
• Do not use the product to transport
corrosive, flammable or explosive
substances such as petrol or other
petroleum products, nitrogenous liquids,
grease, oil, salt water or waste water
from toilets, or liquid that has a higher
viscosity than water.
• The temperature of the pumped water
must not exceed 35°C.
LEVEL ADJUSTMENT
The product must have a float switch that
starts and stops the pump automatically.
The float switch must be fastened so that it can
float freely and start and stop the product. The
float switch can be set variably by undoing the
screws and adjusting the free length of the cord.
FUNCTION CHECK BEFORE
STARTING
Check the function of the float switch by
carefully lifting it up and lowering it down to
check that it closes and switches correctly.
1. Adjust the position of the float switch
so that the water level is controlled
automatically. The gap between the top
of the float switch and float line adjuster
must not be too small, otherwise the float
switch will not work properly.
2. Make sure that the float switch does not
reach the bottom before the pump stops.
WARNING: Risk of running dry.
22
NOTE:
• Risk of material damage. Do not lift the
product by the cord or the outlet tube,
they are not designed to support the
weight of the product. The float switch
must be able to move so that the
product cannot run dry.
• When used hanging on the line: Do not
run the product without the outlet tube
connected. Make sure the product does
not turn around its longitudinal axis.
If the product is used hanging from the
line, the line must be checked at regular
intervals for wear and damage.
MAINTENANCE
CLEANING
Clean the outside of the product. Rinse with
clean water. Remove stubborn stains with a
brush and detergent. Lower the product into a
container with clean water and run for a short
time to flush the inside of the product.
NOTE:
Clean the product after it has not been used
for some time to prevent any deposits or
contaminants causing a blockage.
STORAGE
If there is a risk of frost, dismantle and clean
the product and its accessories and store in a
frost-free place.
NOTE:
Risk of material damage. The product and its
accessories contain water, which means that
they can burst if the water freezes.