Technical Data - Meec Tools 015277 Mode D'emploi

• Do not pump aggressive liquids or
abrasive material.
• Do not pull the power cord or float switch
cord to move the product, and do not use
them to secure the product from moving.
• The product is only intended for
household use and is not suitable for
commercial purposes.
• The manufacturer cannot accept liability
for personal injury or material damage
resulting from improper use.
IMPORTANT:
The product must be connected to the mains
with a residual current device of max 30 mA.
SYMBOLS
Read the instructions.
Approved in accordance with
the relevant directives.
Recycle discarded product
in accordance with local
regulations.

TECHNICAL DATA

Rated voltage
Nominal input power
Pump pressure
Flow
Lifting height
Submersion depth
Particle size
Water temperature
Protection rating
Cord length
Connection
Size
Weight
230 V ~ 50 Hz
1300 W
1.1 bar
416 l/min
max 11 m
max 7 m
max 40 mm
max 35°C
IPX8
10 m
2"(R50)/50mm
L18 x W48 x H24 cm
16.1 Kg
DESCRIPTION
Robust submersible dirty water pump that
can handle particles up to 40 mm. The pump
is suitable for general pumping, extraction
and circulation of clean and dirty water, but
not drinking water. It has a vertical outlet
and a level monitor that can be used in both
automatic and manual mode. To ensure that
this pump lasts a long time the pump housing
and impeller are made of cast-iron, while the
motor body and foot are made of stainless
steel. Minimum water level to start: 150 mm.
Residual level 55 mm.
USE
CONNECTION OF OUTLET TUBE
1. Screw the outlet tube on the outlet
connection. All the connections should be
sealed with jointing tape.
– When using a hose, screw a suitable
hose adapter on the outlet connection.
– For 50 mm outlet tubes, use a
transition nipple with the dimension
2'' x 1 1/2''.
– For 32 mm outlet tubes, use 2
transition nipples, one of each with
the dimension
1 1/22'' x 1''.
2. Press the hose firmly on the hose adapter
and secure with a hose clip.
– A suitable hose can be used for
temporary use. For permanent
installation a tube and non-return
valve are recommended to prevent
return flow when the product is
switched off.
3. Fasten a suitable line to the handle and
lower the product at an angle into the
water, so that no air remains underneath
the product – this prevents suction.
Once the product is submerged,
it can be straightened up.
EN
2'' x 1 1/2'' and
21