Fixing Of Reduction Gear - Key Automation TURBO 250 Manuel D'emploi

FIXING OF REDUCTION GEAR

Open the packaging and check the condition of all the parts of the automation.
• Remove the lid unscrewing the screws see (fig. 5).
• Place the reduction gear on the plate.
• Insert the 4 washers + locknuts to fix the gear (fig. 6).
• If the allowed adjustment of the ratchet is not sufficient it is possible to compensate the
height of the reduction gear working on the 4 more external screws (fig.6).
• Once the adjustment is finished firmly fix the 4 locknuts, making sure that during the entire
run of the gate, the reduction gear is firmly to the ground.
N.B. ANOTHER FIXING OF THE SCREWS IS ADVISABLE AFTER SEVERAL OPERATIONS
Remove 2 screws
Fig. 5
Fig. 6
17
Screws for the height
adjustment of the
reductioon gear
Nuts for fixing the
reduction gear