Explore Scientific SLIMLINE RDC1000 Mode D'emploi page 5

2. Press the [ ] to enter the alarm setting
mode.
3. The setting parameter will flash.
4. Press [ ] or [ ] button to set the
desired data.
5. Press [ ] button to confirm setting and
enter to next parameter.
6. Sequence of setting: Alarm 1 Hour  Alarm
1 Minute  Alarm 2 Hour  Alarm 2 Minute
 Exit
7. Alarm will sound when alarm setting is
finished and turned on.
8. If there is no action in 30 seconds, the setting
will be saved and will exit the setting mode.
TURN ON/OFF ALARM
In alarm display mode, press the [ ] button
to turn on/off the current alarm.
OPERATION
8
1. At the set time, alarm signal rings.
2. During the alarm, press the [
button to delay the alarm by 5 minutes.
3. If you do not press any button to stop the
alarm, it will automatically turn off after 2
minutes.
4. To stop the alarm, press any button except
[ ].
5. The alarm will start again at the next alarm
time, unless you switch off the alarm
function by pressing firstly the [ ] button
and then [ ] button.
SPECIFICATIONS
Dimensions (Main unit):
131 x 68 x 29.5 mm (L x W x H)
Weight (Main unit):
125 g
Temperature display range:
-20°C to +50°C (-4°F to 122°F)
Power:
]
2x AA (LR03) 1.5V batteries
NOTE
• When the temperature is lower than -20°C
(-4°F), the temperature displays LL.L. When the
temperature is higher than 50°C (122°F), the
temperature displays HH.H.
EC DECLARATION OF CONFORMITY
Hereby, Guangzhou Bresser Optical
Instruments Co., Ltd declares that
the RDC1000 product complies with
directive 2014/53/EU.
The full text of the Declaration of Conformity is
available at the following web address:
https.//www.explorescientific.it/certificati-di-
conformita/
RCM DECLARATION OF
CONFORMITY
The adapter complies with
electrical safety, EMC and
radio spectrum regulatory requirements for
products supplied to the Australia or New
Zealand market.
NOTES ON CLEANING
• Remove the batteries before cleaning.
• Only use a dry cloth to clean the exterior
of the device. To avoid damaging the
electronics, do not use any cleaning fluid.
• Protect the device from dust and moisture.
DISPOSAL
Dispose of the packaging materials
EN
IT
DE
FR
ES
9