Power Unit; Recharging The Battery - Etac R82 Wombat Living Mode D'emploi

disinfectant IPA solution. It is recommended to
wipe off any residue and dirt from the device,
using a cloth with warm water and a mild
detergent/soap without chlorine and let it dry
before disinfection.
Materials
• Steel
• Stainless steel
• Plastic: ABS, PE, PA6+GF30, TPU, POM,
PA6+GF15
• Polyurethan
Surface treatment
The following surface treatment processes
were used to protect against corrosion:
• Lacquered surfaces = Polyester powder
• coating or ED-coating
• Non-lacquered steel surfaces = Galvanized

Power unit

For an optimum lifetime the power unit must
be connected to the mains voltages as often
as possible (e.g. every night). Charge the
batteries 12 hours before use.
The batteries must be charged at least
every 3rd month - otherwise there might
be damages due to self-discharge. It is
recommended to test the battery function at
least once every year.

Recharging the battery:

• Remove the plug from the power system
and plug in the charging lead
• Plug the charger into the electricity supply
and switch ON. A yellow light on the
charger will light up
• Charge the batteries until the lamp on the
charger turns green
etac.com
EN XX
56