Sharp AY-XPC12TU Mode D'emploi page 16

SELF CLEAN OPERATION
SELF CLEAN operation will reduce the
growth of mold fungus with Plasmacluster
ions and dry inside of the unit. Utilize the
operation at seasonal change over terms
1
Press the SELF CLEAN button when
the unit is not operating.
• The remote control will display "
(The " " will disappear automatically in
1 minute.)
• The green SELF CLEAN lamp (
the blue PLASMACLUSTER lamp (
the unit will light up.
• The unit will stop operation after 40 min-
utes.
TO CANCEL
Press the STOP button.
• The green SELF CLEAN lamp (
the blue PLASMACLUSTER lamp (
turn off.
NOTE:
• You cannot set the temperature, fan speed, air
flow direction or timer setting during the SELF
CLEAN operation.
• Mold fungus already grown can not be
eliminated by this operation.
RR_OM_10_lang.indb GB-12
DISPLAY BUTTON
Press the DISPLAY button when the lamps
on the unit are too bright. (The green OP-
ERATION lamp and the orange TIMER
lamp cannot be turned off.)
.
1
During operation, press the DIS-
PLAY button.
".
• The blue PLASMACLUSTER lamp (
and/or the orange FULL POWER lamp
(
) and
TO LIGHT UP
)on
Press the DISPLAY button again.
) and
)will
AUXILIARY MODE
Use this mode when the remote control is
not available.
TO TURN ON
Press the AUX button.
• The green OPERATION lamp (
• The mode and the temperature setting are
automatically selected according to the room
temperature and the outdoor temperature
when the unit is turned on. The fan speed is
set to AUTO.
TO TURN OFF
Press the AUX button again.
1
• The green OPERATION lamp (
1
EN-14
)will turn off.
) will light up.
) will turn off.
)
1
AUX
2014-02-21 08:53:34