Publicité
Cutting without Remote
• Before cutting, ensure blades are properly installed.
• The tool can be set on the ground or hand held
during use.
• Insert the workpiece squarely between the blades.
Do not attempt to make angled cuts as it will dam-
age the workpiece and blades.
• Ensure the remote cut switch is set to manual.
1. Grasp handles firmly and pull and hold the trigger
through the operation. When the cut is complete
or the tool shuts off, release the trigger. An LED
will light when the trigger is pulled. NOTE: Tool
and workpiece may move slightly during the cut.
2. When the cut is complete, pull the release trigger
to open the blades. The ram blade will return to
the starting position.
To reduce the risk of injury, only
WARNING
cut recommended materials for the
blades (see "Specifications"). Do not attempt to
cut other materials.
Cutting Tips
• Cut farther in from the end of the material to avoid
crooked cuts.
• Do not attempt angled cuts as it will damage the
blades. Hold the material squarely between the
blades.
• Cut clean material to extend the blade life. Wipe dirt
and debris from material and blades before begin-
ning the cut.
Jammed Blades
Dirt and debris can cause the blades to become
jammed together after a cut. If the blades do not
open when the release trigger is pulled:
1. Press and hold the release trigger to ensure the
tool has reset.
2. WARNING! Remove battery to avoid starting the tool.
3. While pulling the release trigger, use a rubber
mallet to tap the ram blade until the blades open.
4. Clean any dirt and debris from the blades before
starting another cut.
Manual Release Button
If the jaws need to be opened without completing
the cycle, press and hold the manual release button.
Hold tool securely until the ram blade retracts fully.
MAINTENANCE
To reduce the risk of injury, always
WARNING
unplug the charger and remove the
battery pack from the charger or tool before
performing any maintenance. Never disassemble
the battery pack, charger, or tool, except as pro-
vided in these instructions. Contact a MILWAUKEE
service facility for all other repairs.
Maintaining Tool
Keep this tool, battery pack and charger in good
repair by adopting a regular maintenance program.
Inspect the tool for issues such as undue noise,
misalignment or binding of moving parts, breakage of
parts, or any other condition that may affect the tool
operation. Return the tool, battery pack, and charger
to a MILWAUKEE service facility for repair. After six
months to one year, depending on use, return the
tool, battery pack and charger to a MILWAUKEE
service facility for inspection.
If the tool does not start or operate at full power with
a fully charged battery pack, clean the contacts on
the battery pack. If the tool still does not work prop-
erly, return the tool, charger and battery pack, to a
MILWAUKEE service facility for repairs.
Cutting Head and Blades
Inspect the cutting head and blades for cracks or
damage. Do not use damaged cutting head or blades.
Replace the blades when they become chipped or
damaged.
Pairing a New Remote
For pairing instructions, refer to the Service Parts List
available on the product page at MilwaukeeTool.com.
8
Publicité
