Control Panel & Lcd Operations; Introduction - INFOSEC UPS SYSTEM E4 Evolution II 100k TT S Manuel Utilisateur

3. Control Panel & LCD Operations

3-1. Introduction

This control panel and display screen are located at the front panel of the UPS. This interface allows to
monitor all measured parameters, the UPS status, the battery status and alarms. The control interface is
divided into four sections: (1) LCD display, (2) LED indications, (3) Power Button, (4) Audible Alarm, as
shown in Figure 3-1.
Table 3-1: LED Indications
LED Color
LINE Green
BYPASS Yellow
LOAD Green
INV Green
BATTERY Red
FAULT/
Red
ALARM
Table 3-2: Power Button
Control Key
Power On/Off
INFOSEC UPS SYSTEM – 15, Rue du Moulin – 44880 Sautron – France – www.infosec-ups.com
93
Hot Line Tel : +33 (0)2 40 76 15 82 – fax : +33(0)2 40 94 29 51 – hotline@infosec.fr – 02 19 AA 59 203 07
Figure 3-1 Control Panel
(5) LCD display: Graphic display and all measured parameters.
(6) LED indications. Refer to Table 3-1.
(7) Power Button. Refer to Table 3-2.
(8) Audible Alarm. Refer to Table 3-3.
Status Definition
On Input source is normal.
Flashing Input source is abnormal.
Off No input source
On Load on Bypass.
Flashing Input source is abnormal.
Off Bypass not operating.
On There is power output for the load.
Off There is no power output for the load.
On Load on inverters.
Off Inverters not operating.
On Load on Battery.
Flashing Low battery
Off Battery converter is normal and battery is charging.
On UPS fault.
Flashing UPS alarm.
Off Normal.
Description
Turn on UPS or Turn off UPS. (hold 2-Sec)