Rear Panel View - INFOSEC UPS SYSTEM E4 Evolution II 100k TT S Manuel Utilisateur

Interface and Communication
This UPS comes equipped with various communication devices. Please refer to chapter 4 Interface and
Communication for further details.
Power Stage/Module
Each power stage/module includes a power factor correction rectifier, a battery charger, an inverter and
control circuit.
No. Item

Fan

DIP Switches

Battery Start Button

FAULT LED

RUN LED

2-3. Rear Panel View

There are various breakers located on the rear panel of the UPS.
INFOSEC UPS SYSTEM – 15, Rue du Moulin – 44880 Sautron – France – www.infosec-ups.com
84
Hot Line Tel : +33 (0)2 40 76 15 82 – fax : +33(0)2 40 94 29 51 – hotline@infosec.fr – 02 19 AA 59 203 07
Air enters the power stage/module through the front grills and exhausted
through rear of the module. Please do not block the ventilation vent port.
There are three DIP switches for power stage/module address setting. In the
same cabinet, each power stage/module ID MUST be exclusive. Please refer
to Table 2-1 Power Stage/Module ID
When there is no AC input, use this button to start the battery power for the
UPS.
ON
ON/OFF 0.5 sec
ON
ON/OFF 0.5 sec
ON/OFF 0.15 sec
1. Dry contact port X1
2. Dry contact port X2
3. SNMP slot (SNMP card optional)
4. Extended communication
slot(Extra Comm. card optional)
5. RS-232 port
6. USB port
Description
The power stage/module is in fault condition.
The power stage/module IDs in conflict.
The power stage/module normally works as a slave
unit.
The power stage/module normally works as a master
unit.
The CAN BUS communication does not work.