Gima TOBI Mode D'emploi page 15

Masquer les pouces Voir aussi pour TOBI:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

• Connect the short silicon tube (1), with antibacterial filter (2), to
the suction connector (3). The other tube, with one end
connected to the filter must be connected with the other end to
jar's lid connector (4) where has been fixed the red float.
When the 90% of the volume of the jar is reached there is the
activation of the security float (the float close the aspiration
connector on the jar) to avoid liquid penetration inside the
device. The device must be used on a plan of horizontal
operation.
• Connect the long silicon tube (5) to the other jar's lid connector
(6)
• Connect the other end of the long silicon tube (5) to the probe plastic
connector (8) then connect the suction probe to it.
• Connect the power cord to the device then connect the plug to
the electrical mains supply.
• Push switch (7) on position I to start suction
• Once finished push switch on 0 position and unplug.
• Unscrew the jar's lid and fill the jar 1/3 full or ordinary water
(this for an easy cleaning operations and an rapid reaching of
the functionally vacuum) then rescrew the lid on the jar
correctly.
• To extract the accessories and start with cleaning.
Ensure that the IN marker on the filter is on the side facing the collection jar lid and fitted into the "VACUUM".
MAKE SURE THAT CHILDREN AND/OR MENTALLY ILL PEOPLE DO NOT USE THE DEVICE WITHOUT ADULT SURVEILLANCE
COMPLYING WITH THE NEW EUROPEAN RULES, GIMA INDICATES THE IMPORTANT POINTS TO PROTECT INSTRUMENT AND OPERATORS HYGIENE.
THESE RULES MUST BE RESPECTED IN ORDER TO GUARANTEE HYGIENE AND SAFETY TO ALL THE PEOPLE OPERATING WITH THE INSTRUMENT TO
OBTAIN QUALITY AND WELL BEING.
Every returned instrument will be hygienically checked before repairing. If GIMA finds instrument not suitable for repairing due to clear signs of
internal or external contamination, the same will be returned to customer with specification of NOT REPAIRED INSTRUMENT, accompanied by an
explanation letter. GIMA will decide if contamination is due to bad functioning or misuse. If contamination is due to bad functioning, GIMA will
substitute the instrument, only if a SALE RECEIPT and STAMPED GUARANTEE accompany the same.
GIMA is not responsable for contaminated accessories, they will be substitute at customer's expenses.
For this reson it is COMPULSORY to carefully disinfect the external part of the instrument and accessories with a cloth soaked in methylated spirits
or hypochlorite-based solutions. Put the instrument and accessories in a bag with indication of disinfecting. We also request to specify the kind of
fault, in order to speed up repairing procedures. To this end, please read the instructions carefully in order to avoid damaging the equipment
through improper use. Always specify the fault encountered so that GIMA can establish whether it falls into the category of the faults covered by
the guarantee.
The manufactured cannot be held liable for accidental or indirect damages should the device be modified, repaired without
authorization or should any of its component be damaged due to accident or misuse.
Any minimal modification / repair on the device voids the warranty and does not guarantee the compliance with the technical
requirements provided by the MDD 93/42/EEC (and subsequent changes) Directive and its normatives.
INSTRUCTION FOR USE
A wrong connection causes immediate destruction in case of contact with sucked liquids.
NEVER USE THE DEVICE WITHOUT JAR AND / OR PROTECTION FILTER
ALWAYS PLACE THE DEVICE IN POSITIONS FOR EASY DISCONNECTION
RULES FOR RETURNING AND REPAIRING
15

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

28222

Table des Matières