Moving The Unit; Energy Saving Tips; Changing The Light Bulb; Door Reversal Instructions - Frigelux Rc425Xes Manuel D'utilisation

Moving the unit

After any movement, it must not be connected for 4 hours. This delay allows the coolant to be adjusted.

Energy saving tips

•
The refrigerator should be located in the coolest area of the room, away from heat producing
appliances or heating ducts, and out of the direct sunlight.
•
Let hot foods cool to room temperature before placing them in the refrigerator. Overloading
the refrigerator forces the compressor to run longer. Foods that freeze too slowly may lose
quality, or spoil.
•
Be sure to wrap food properly, and wipe containers dry before placing them in the refrigerator.
This cuts down on frost build-up inside the refrigerator.
•
Refrigerator storage bin should not be lined with aluminum foil, wax paper, or paper toweling.
Liners interfere with cold air circulation, making the refrigerator less efficient.
•
Organize and label food to reduce door openings and extended searches. Remove as many
items as needed at one
Note: Once the refrigerator is used, you'd better use it continuously; and under normal
circumstances, do not stop its use, so as not to affect the service life.

Changing the light bulb

This appliance consists of light-emitting diodes (LEDs). This type of
diode cannot be changed by the consumer. The lifetime of these LEDs
is normally sufficient for no change to be made. If however, and despite
all the care taken during the manufacture of your appliance, the LEDs
were defective, please contact your after-sales service for any
intervention.

Door reversal instructions

Your refrigerator is built with a reversible door. You have the choice of either opening it from the left or
the right side. In order to reverse the opening direction of your door, please follow these simple
instructions.
Make sure that your refrigerator is unplugged.
Remove the top hinge cover and the hinge on the right.
Remove cover on the left and unplug the cable which
1
connects door and cabinet. Then take out lamp switch from
hinge cover.
Lift the door upwards to disengage it from the middle hinge,
2
put the door to one side and lay it down gently on a padded
surface.
time and close the door as soon as possible.
32