Frigelux RC425XES Manuel D'utilisation page 27

2. Temperature setting
Short press K2 button to adjust the refrigerator temperature between 2°C and 8°C according
to your needs, the L2~L6 indicator lights up to indicate the corresponding temperature setting
value.
3. Mode functions
A）Fast-cooling mode
Activate: Long press K2 button for more than 3 seconds to activate the Fast-cooling mode,
then L1 indicator light turns on, the other indicator light turns off, the fast-cooling mode stays
activated for 6 hours.
Disable (4 ways):
1. Long press the K2 button for more than 3 seconds to turn off the "Fast-cooling" mode
and return the temperature to 4°C (L4 indicator lights up);
2. Press the K1 button to enter the "Intelligent" mode and automatically exit the Fast-
cooling mode.
3. Powering-down and powering-up again deactivates the rapid cooling mode and returns
the temperature to 4°C (L4 indicator lights up);
4. The Fast-cooling mode stops automatically after 6 hours of operation, and the
temperature returns to 4°C (L4 indicator lights up).
B）Intelligent mode
Activate: Short press K1 button to activate Intelligent mode, L7 light is on, other light is off.
Disable: Press K2 to regulate the temperature or activate the Fast-cooling mode.
NOTE:
• If the unit is unplugged, lost power, or turned off; you must wait 3 to 5 minutes before
restarting the unit. If you attempt to restart before this time delay, the refrigerator will
not start.
• If you choose to change the thermostat setting, adjust thermostat control by one
numerical increment at a time. Allow several hours for temperature to stabilize between
adjustments.
Do not leave the door open for too long so that the indoor temperature does not rise
too much.
"COLD ZONE" SYMBOLS (Depending on models)
You will find the symbol opposite in your refrigerator. It clearly shows the
location of your appliance's coldest zone: the temperature here is + 4°C or
less. A temperature indicator here enables you to check that your
refrigerator is working correctly.
TEMPERATURE INDICATOR (Depending on models)
Temperature to set
Correct temperature
27