VOLTCRAFT PLC3000 Mode D'emploi page 35

Energy-saving stand-by mode
Set the energy-saving stand-by mode from 0.1 to 9.9 watts. You may
activate or deactivate the standby function. You may also use the "Auto Cut
Off" function to automatically switch off the connected appliance in case the
limit is exceeded.
• Tap on the
functions:
Graph, measurement (readings) and rates (costs). The
is also shown in the "Dashboard" view and therefore it can be directly
controlled.
Graph
The energy consumption will be graphically displayed in KWh. It is possible
to send the graph via email. When sending an email, follow the instructions
provided by the app.
Measurement
You may display readings for "Voltage", "Current", "Wattage", "Performance
factor", "Frequency" and "CO
Costs
The display will show the current rate, total energy consumption and
estimated costs by day, week, month and year. If the rate is changed, the
estimated costs will be adjusted accordingly.
Reset historical data
Use this function to delete stored information. Tap on >Reset historical
data< to execute this function. The values for current rate, CO
timer setting will still be saved in the memory, so you do not need to enter
these values again.
data icon in the lower right field to display the following
emission".
2
data icon
and the
2
35