Publicité
ENGLISH
5.1. The dust tank is full. Empty it and clear the high-efficiency filter if it is blocked.
5.2. The high-efficiency filter is blocked, clear it.
5.3. The main brush is tangled with foreign matter, please clear it up.
6.1. Bad Wi-Fi signal. Check the Wi-Fi signal.
6.2. The Wi-Fi connection is unstable. Reset the router, check if there are any App updates and
try again.
6.3. Make sure that your device's mobile data are deactivated to improve the binding process.
7.1. Check if the robot is in Night mode and switch mode. The robot does not carry out scheduled
cleaning cycles under this mode.
7.2. Make sure the robot is connected to the network, it will not be able to carry out scheduled
cleaning tasks without being connected.
8.1. The robot will map and calculate a new route after operating under spot cleaning or after
having changed its starting position.
8.2. If the charging base is very far away from the robot, it will not be able to charge back
automatically. Put the robot back on the charging base manually.
9. Make sure the robot is not in Sleep mode, it will not resume cleaning under this mode. It
won't resume cleaning when it is placed manually on the charging base.
10. Make sure the robot is successfully connected to the network and always in the range
covered by the Wi-Fi signal.
11. Make sure the robot and the charging base are in an area with good Wi-Fi signal, reset the
router and try connecting them again.
12.1 Make sure that the areas to be cleaned are properly illuminated.
12.2 Clean the lens with a soft, clean cloth and make sure that the sensor is not blocked. Avoid
using detergents or sprays during clean-ups.
9. TECHNICAL SPECIFICATIONS
Model: Conga 9090 AI
Product reference: 5416
100-240 V ~ 50/60 Hz
Battery: 14.8 V, 6400 mAh
Frequency bands: 2.412-2.472 GHz 5.150-5.250 5.250-5.350 GHz 5.470-5.725 GHz
Maximum Transmission Power: 16 dBm
Made in China | Designed in Spain
50
Publicité
