Publicité
ENGLISH
-
Dry it thoroughly before assembling it back in order to ensure efficient operation.
Dust tank.Fig. 24.
-
Take the dust tank out.
-
Open the dust tank cover and empty it.
-
Use the cleaning brush to clean the inside of the dust tank.
-
Install the dust tank back in the robot.
High-efficiency filter.Fig. 25.
Remove the high-efficiency filter and shake it to remove all the dust.
Note
Replace the high-efficiency filter every 3 months depending on the frequency and type of use.
Clean the filter periodically with a brush to avoid blockage. Do not use water or detergents.
Side brush.Fig. 26.
Remove and clean the side brushes regularly.
Recommendation
In order to ensure a perfect cleaning, it is suggested to replace the side brushes every 3
months, depending on the frequency and type of use.
Free-fall sensors.Fig. 27.
Clean the free-fall sensors with a soft cloth regularly.
Warning
Always transport the product turned off and in its original package.
Visual detection sensor.Fig. 28
Clean the lens with a soft, clean cloth. Avoid using detergents or sprays during clean-ups.
These clean-ups must be made at least once a week, depending on the use.
7. BATTERY REPLACEMENT AND CHARGING
-
Do not use any other battery, power adapter or charging base than the one officially
provided by Cecotec.
-
Do not use non-rechargeable batteries.
-
Do not remove, dismantle or attempt to repair the battery or the charging base.
-
Do not place the charging base near heat sources.
48
Publicité
