Publicité
Restricted area mode
-
Select this mode and delimit in the map specific areas where you do not want the robot to
clean. You can set more than 1 restricted area at the same time on the map.
-
It can only be activated from the App. It is recommended to set starts as restricted areas
to avoid setbacks.
Twice mode
-
Use this mode to carry out a deep, thorough cleaning of your home.
-
It can be combined with Edge, Spiral, Spot or Smart Area modes. The robot will carry out 2
full cleaning cycles and then will return directly to the charging base.
Final cleaning
Before returning to the charging base, the robot moves forward and backward several times in
order to eliminate any rests of dust from the brush.
6. CLEANING AND MAINTENANCE
Main brush
-
Turn the robot around and press the main brush's release button to take the cover out.
-
Take the main brush out and clean the compartment.
-
Clean the main brush with the provided tools and use water and soap if necessary.
-
Place the main brush in its position and fasten the cover's clip.
Recommendation
Replace the main brush every 6-12 months to ensure efficient operating (depending on the
frequency and type of use).
Fig. 21.
-
Main brush cover
-
Tab
-
Main brush
-
Compartment
Silicone brush.Fig. 22.
-
To clean the silicone brush, follow the instructions on the previous section to remove it
from the robot and wash it with water and soap.
-
Dry it thoroughly before assembling it back in order to ensure efficient operation.
Jalisco brush.Fig. 23.
-
To clean the Jalisco brush, follow the previous section's stepsand clean it with water.
ENGLISH
47
Publicité
