Publicité
-
Do not use a wet cloth to wipe any of the parts of this product.
-
If the robot is not going to be used for a long time, remove the battery from the product and
store it in a dry and safe place. It is suggested to charge the battery every month in order
to avoid damage to the battery.
-
Do not dispose of waste batteries at will. It is suggested to hand them over to professional
organizations for correct treatment.
8. TROUBLESHOOTING
Problem
1.
The robot does not start up or does not clean.
2.
The robot cannot charge or return to the charging base.
3.
The robot does not work properly.
4.
The robot emits a strange noise during cleaning.
5.
The robot does not clean efficiently or dust leaks from the robot.
6.
The robot could not connect to Wi-Fi.
7.
The robot did not carry out the scheduled cleaning task.
8.
The robot does not return to the charging base after spot cleaning or after changing
starting position.
9.
The robot does not resume cleaning.
10.
The robot is always offline.
11.
Connection between the mobile phone and the robot failed.
12.
The visual detection sensor does not recognise
Solution
1.1. The robot cannot operate with low battery. Allow it to charge before operating it.
1.2. The room temperature is below 0ºC or above 50ºC. Operate the robot in a room where the
temperature is between the stated temperature range.
2.1. There are too many obstacles near the charging base, relocate the charging base to an area
free of obstacles.
2.2. Clean the charging terminals.
2.3. Make sure the power switch is turned on.
2.4. The robot is too far away from the charging base, place it closer and try again.
2.5. There is very little free space around the charging base. Make sure the charging terminals
are clean.
3.1. Turn the robot off, switch it off and turn it on again.
3.2. Once the robot is turned on and has left the charging base, hold down the Back home
button on the robot until it beeps. Immediately after, let go the button and press it again until
the robot starts speaking. This way the robot will be restarted.
4. The main brush, side brush or omnidirectional wheel may have foreign matters tangled, stop
the robot and clear it up.
objects.
ENGLISH
49
Publicité
