Telephone General Programming; Set Time - Esse-ti Fly View Operator Mode D'emploi Pour L'utilisateur

Wait until the green LED's start scanning. Press the programming button
when LED L7 turns on.
The red LED's start scanning. Press the programming button when the
eighth RED LED turns on.
T
ELEPHONE GENERAL PROGRAMMING
Be sure that the phone is in standby mode.
Press " SET/STORE" to access the programming mode;
Press "UP" or "DOWN" to scroll through the seven programming modes
(from 1 to 7):
1
2
3
4
5
6
7
Press " SET/STORE" to set the selected programming mode.
The display shows the current setting and the modifiable parameter
starts flashing. Use "UP" or "DOWN" to scroll through the different
options or enter a value with the numerical buttons (enter a value for
each flashing digit). To set more than one parameter, press
"SET/STORE" to save the current parameter. The next parameter starts
flashing;
Press "DELETE" to exit the programming mode.
Note: When the setting is completed, the next parameter appears on
the display. The programming mode is exited if no key is
pressed within 10 seconds.

Set time

Be sure that the phone is in standby mode.
92
Date and time "date"
Local area code "code"
Flash time "flash"
IP mode "ip"
Brightness "lcd"
Ring "no_r"
Ring tone "r_tone";
INSTALLATION