Extension Position Programming - Esse-ti ST350 Mode D'emploi

Pins 2 and 3 (voice) must be connected to the telephone switch numbered
terminal that corresponds to the extension number to be connected. No polarity
must be complied with.
Pins 1 and 4 (data line) must be connected to the switch signalling terminals.
For more information please refer to the PABX instruction manual. The
polarity shown in the table must be complied with. If, by mistake, wires are
connected with inverted polarity, the phone leds and the leds of any other
ST350 or system telephones will not turn on.
To connect the telephone use the plug/plug cable
E
XTENSION POSITION PROGRAMMING
Allows the user to set which port the telephone switchboard is connected to.
These parameter must be programmed for proper
PABX made before October 2008
Press the Prog key.
From another extension:
Lift the handset.
Dial 6.
Dial the extension number of ST350 phone.
Conversation in hands free mode starts.
Replace the handset.
PABX made after October 2008
Press the Prog key.
Leds starts flashing.
38
Warning
supplied.
telephone operation.
INSTALLATION