Publicité
SYMPTOM
CAUSE
The grass is taller than 15 cm.
Landroid Vision frequently
There is grass around suspen-
collides.
ded objects such as a hanging
fence or a slide.
Landroid Vision operative
system crashes when
Software or display fault.
charging or on standby.
Landroid Vision fails to charge
due to over temperature pro-
Landroid Vision shuts
tection and is powered off.
off when docking in the
charging pile.
Poor connection.
There are continuous obstacles
in the working area.
Landroid Vision stops in
The cutting height is set too low
the working area.
for the length of the grass or the
grass is too dense.
There is an inclined obstacle on
Landroid Vision flips over.
the lawn.
Please check your router has the
correct settings.
Landroid Vision fails to
connect to the internet.
Please check whether the router
is disconnected or Wi-Fi SSID is
changed.
The Wi-Fi signal is weak.
The software upgrade
The battery level is less than
fails.
50%.
Environmental protection
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with
your Local Authority or retailer for recycling advice.
Remove the used battery pack from the appliance and dispose of it at the most convenient recycling facility. If in doubt, consult
your local environmental protection department.
SOLUTION
Trim the grass to below 15 cm.
Lay magnetic strips or set up a 5 cm non-grass pathway around
the area.
Restart Landroid Vision.
Place the charging station in a shady area or wait until the tem-
perature has cooled down.
Check the LED light on the charging pile. Check the connection
between the contact pins located on the charging pile and the
charging strip.
Lay magnetic strip or by creating a non-grass pathway that is
more than 5 cm wide around the obstacles.
Raise the cutting height and then gradually lower.
Exclude the obstacle from Landroid Vision's working area.
Make sure your router is 2.4GHz or 5GHz. If your router has two
settings, please enable the 2.4GHz or 5GHz band.
Make sure your router is set to 802.11 mode and wireless setting
is b/g/n mixed.
Make sure your router has the SSID Broadcast function enabled
when you connect the machine with the APP.
You can close it after you connect successfully.
Make sure DHCP function is enabled.
If you changed your Wi-Fi network, you need to connect Landroid
Vision to the new network.
If you have a "Fritz! box" router, please make sure activate
"Allow communication between devices in same network" in the
settings.
Make sure the router is connected and Wi-Fi SSID is correct.
Move closer to the router to strengthen the signal.
Place Landroid Vision on the charging station or ensure that the
battery level is above 50%.
EN
21
Publicité
