Publicité
restart it. If the problem cannot be solved, please contact our Customer Service for help.
TROUBLESHOOTING
If your Landroid Vision does not work correctly, follow the trouble shooting guide below. If the fault persists, contact Customer
Service.
SYMPTOM
CAUSE
The LED light on the
charging pile does not
There is no power.
turn on.
Landroid Vision turns on,
Landroid Vision is searching for
but the blade disc does
the charging station.
not spin.
The blade disc is unbalanced.
Landroid Vision vibrates.
Blades may be damaged.
Landroid Vision does not work
enough hours per day to cut the
grass.
Mowing area is too big for the
size of Landroid Vision you have.
The blades are dull and not sharp. Change all the blades and screws in order to balance the bade disc.
Grass is being cut
The cutting height is set too low
unevenly.
for the length of the grass.
Grass or another object has
wrapped around the blade disc.
There is a build-up of grass in the
blade disc or motor frame box.
Recognition error
Programming error
There are obsacles between the
The secondary area is
RFIDs in the pathway.
not mowed.
The boundary of the passage wi-
thin 1.5 m range of the boundary
wire for the RFID is curved.
Poor connection caused by
debris on the charging strip.
The charging time is
far more than the rated
The charging protection
charging time.
program is activated due to high
temperature.
The mower does not
There is no power.
charge.
SOLUTION
Check the charging station is connected properly to the charger
and the charger is connected to a suitable power supply.
This is normal: when Landroid Vision needs to recharge, the blade
disc does not rotate while it is searching for the charging station
automatically.
Check the blades and replace them if damaged.
Remove debris and foreign objects from the blades and blade disc.
Try adding more hours to the mowing schedule.
Try decreasing the size of the mowing area or increasing working
time.
Raise the cutting height and then gradually lower.
Check the blade disc and remove any grass or other objects that
might prevent it spinning.
Make sure the blade disc rotates easily. If need be, you may take
off the blade disc and then remove the debris.
Remove the obstacles, such as piles of leaves, weeds and wil-
dflowers.
Make sure the RFIDs are installed correcly and reprogrammed.
Remove the obstacles.
Ensure that there is no boundary curved within 1.5 m range of
the boundary wire for the RFID.
Clean the contact pins located on the charging pile and the
charging strip on Landroid Vision using a cloth.
Place the charging station in a shady area or wait until the
temperature has cooled down.
Check the power cord is connected properly to the charger and
the charger is connected to a suitable power supply.
Make sure both the charging strips on the mower touch the
center of the charging contacts on the charging pile.
EN
19
Publicité
