Publicité
MESSAGE
CAUSE
-E05
Error lifted
-E06
Error Upside Down (tilted)
-E07
Battery charge error
-E08
Error find home timeout
-E09
No map
-E10
Mower is locked
Battery temperature is out of
-E11
range
-E12
Camera is covered
-E13
Camera error
-E14
Insufficient light
-E16
Transition failure
NOTES
A. Before turning power on, always check Landroid Vision is inside its working area.
B. If for any reason—i.e. a party, children playing...—you want to park your Landroid Vision in the charging station: press
. Landroid Vision will go to its station and stay there. Please note Landroid Vision will now wait until the next scheduled mowing
session. If you want to re-start it at anytime, press
C. If an error repeatedly occurs in the same area of your lawn, you might have a problem with the working area so please refer to
the installation instructions and check your set up is correct with its help.
D. If your lawn is divided in two separated areas, connected by a corridor less than 1m wide, one of which is not provided with the
charging station: when Landroid Vision runs out of charge, take it manually to the charging station.
E. If Landroid Vision runs abnormally once in a while, please reset it by turning it off and removing the battery for 30 seconds, then
18
ACTION
Turn power off.
Take Landroid Vision to a lawn area clear of obstacles, turn power on.
Press
then
.
If the error message is still displayed: turn power off, turn Landroid Vision
upside-down and check there's anything that can cause Landroid to be
lifted up.
Remove any possible object, turn Landroid upright, turn power on.
Press
then
.
Turn Landroid Vision upright.
1) Battery's temperature is too high (more than 55°C) when charging.
Place the charging station in a shady area or wait until the temperature
has cooled down.
2) Battery's temperature is too low. The outside temperature doesn't
allow your Landroid Vision to work. It's time to recover it for winter time.
3) Poor connection: check the connection between the contact pins
located on the charging station and the charging strip and that the
charging base is on a perfect flat ground.
4) Power supply is broken: please contact Customer Services.
1) Charging station is badly placed (not on a flat ground), Landroid Vision
doesn't find pins and doesn't stop. Check the station.
2) Landroid Vision runs out of battery before reaching the charging
station. Take Landroid Vision back to the charging station.
1) Make Sure the charging station is on your lawn (not indoor).
2) Take Landroid Vision back to the charging station.
3) Press
then
.
4) Landroid Vision circles in place once and then go to work.
If your lawn has Multi-Zone and you have installed RFIDs, please add the
zones and passages in the app. Landroid Vision will record the size and
perimeter after completing the edge routine for the first time.
Need contact Customer Services to unlock.
The battery temperature is too high. When the temperature is lowered to
53°C, the machine will return to normal work.
Please clean the cover on the camera.
1) Turn power off.
2) Take Landroid Vision to the charging station, and turn power on.
3) Press
then
.
4) If the problem cannot be solved, please contact Customer Services.
Landroid Vision would stop working when the light is too weak.
Please check if the RFID installation is correct.
Please ensure that there are no obstacles in the passage.
then
to start your Landroid Vision.
EN
then
Publicité
