Publicité
SYMPTOM
Landroid Vision is starting
to have shorter run-times
between charges.
Landroid Vision is not
operating at the correct
time.
Landroid Vision can not
find the charging station.
Landroid Vision cannot
correctly dock with the
charging pile.
The green light on the
charging pile turns
on before charging is
complete.
Landroid Vision wheels
skid or repeatedly slip.
Landroid Vision slips out
of its working area.
20
CAUSE
Something is clogging in the
blade disc creating friction and
increasing power consumption.
Landroid Vision is shaking heavily
because the blade disc is unba-
lanced.
The battery may be exhausted
or old.
The working time is up.
The clock is not set to the cor-
rect time.
Programmed cutting times for
Landroid Vision are not correct.
The percentage of weekly ope-
rating time set through APP has
changed.
The direction of the charging
station is incorrect.
There are obsacles in front of the
charging station.
The QR code is sheltered.
Environmental influences.
Poor connection caused by
debris on the charging strip.
The charging station is overhea-
ting or overcooling.
Obstacles, such as twigs and
branches may be lodged under
Landroid Vision.
The lawn is too wet.
Low grip of Landroid Vision drive
wheels.
The slope is steeper than 30%
(17
).
o
Recognition error.
There is grass whose height is
higher than 15 cm.
SOLUTION
Take off the blade disc and clean it. Maybe the grass is too high
and too thick.
Check the blade disc and blades, remove debris and foreign
objects from the blades and blade disc.
Replace the blades with a new set.
Replace battery.
Reset the working time.
Set the clock to the correct time.
Change the time settings for the mower to start and stop.
Set the correct percentage through APP.
Make sure Landroid Vision dock right towards the charging sta-
tion and departures in anti-clockwise direction.
Please remove the obstacles within the 2 m in front of the char-
ging station.
Make sure the QR code is clear and that there is nothing directly
on it or above it.
Restart Landroid Vision.
Clean the contact pins located on the charging pile and the char-
ging strip on Landroid Vision using a cloth.
Place the charging station in a shady area or wait until it reaches
the normal temperature.
Remove objects from underside of Landroid Vision.
Exclude the wet or soft ground areas by using the magnetic strip
or by creating a non-grass pathway that is more than 5 cm wide
until the lawn is dry again.
Please check the wheels are clean and free of mud in order to
have the maximum grip possible.
Exclude the sloped area by using the magnetic strip or by cre-
ating a non-grass pathway that is more than 5 cm wide directly
beside the slope.
Remove the obstacle if there is one. Using the magnetic strip or
by creating a non-grass pathway that is more than 5 cm wide on
the lawn edge ensure that the mower functions correctly.
Trim the grass to below 15 cm. Lay magnetic strips or set up a 5
cm non-grass pathway if there are steps, cliffs or a pond below
the grass.
EN
Publicité
