Faults And Troubleshooting; Fault Indicator And Error Codes - Bosch BCR1 Série Mode D'emploi

Faults and troubleshooting

Fault indicator and error codes

If a fault occurs in the robot vacuum, it will stop cleaning immediately. The fault indi-
cator and/or a coloured error code will indicate a fault.
Eliminate the cause of the fault.
Start the (cleaning) programme again.
Signal Cause
The robot vacuum cannot
find the charging station.
The wheels are jammed.
The brush roller is stiff.
The brush roller is jammed
and will not move.
The brush roller or the navi-
gation sensors are dirty.
The fan is clogged.
110
Solution
Please place the robot vacuum on the
charging station.
Check how easily the large driving wheels
turn. If necessary, clean all the wheels as
described in "Cleaning the wheels and
rollers".
Check how easily the brush roller turns
and, if necessary, clean the brush roller
as described in "Cleaning the brush rol-
ler".
Check how easily the brush roller turns
and, if necessary, clean the brush roller
as described in "Cleaning the brush rol-
ler". Switch the appliance off and on again
using the on/off switch.
Please clean the brush roller as described
in "Cleaning the brush roller".
Please check the navigation sensors for
dirt and, if necessary, clean the sensors
as described in "Cleaning the navigation
sensors".
Please take out the dust container, check
the robot vacuum for foreign objects and,
if necessary, remove these. Switch the
appliance off and on again using the on/
off switch.
en