EINHELL GP-LS 18/28 Li T BL Mode D'emploi page 15

function switch (Item 5.1 / Item 10) and
continuing to hold it.
d) Take account of the maximum cutting
capacity (see Technical Data) when cutting
branches.
e) If you try to cut branches that are too thick or
too hard for the tool to cut through, the cutting
blade will open automatically.
7. Cleaning and maintenance
HAZARD!
Always take the battery out of the equipment
before starting any cleaning work.
7.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it down with compressed air at
low pressure.
•
We recommend cleaning the equipment
immediately each time after use.
•
Clean the equipment regularly with a damp
cloth and some soft soap. Do not use
cleaning agents or solvents; these may
be aggressive to the plastic parts in the
equipment. Ensure that no water can get into
the interior of the equipment. The penetration
of water into an electric power tool increases
the risk of an electric shock.
7.2 Maintenance
Lubricating the branch shears blade (Fig. 17)
The branch shears blade must be lubricated
each time after it has been used and whenever
required. Use universal oil spray or the ball
pressure lubricator (see arrow) with a matching oil
spraying can.
Resharpening the moving cutting blade (Fig.
17)
If the cutting blade (Item 1) becomes blunt, you
can sharpen it yourself (Caution! Wear protective
gloves!) or have the blade replaced by the
customer service team.
•
With the blade fully open, switch off the tool
and remove the battery.
•
Sharpen the cleaned cutting blade with a
suitable grinding tool (e.g. a wet grinding
stone, wet grinding paper).
Anl_GP_LS_18_28_Li_T_BL_SPK7_NA.indb 15 Anl_GP_LS_18_28_Li_T_BL_SPK7_NA.indb 15
EN
•
There are no other parts inside the tool which
require maintenance.
8. Disposal and recycling
The equipment is supplied in packaging to
prevent it from being damaged in transit. The
raw materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
9. Storage
Store the equipment and its accessories out
of children's reach in a dark and dry place at
above freezing temperature. The ideal storage
temperature is between 50°F and 104°F (10°C
and 40°C). Keep the electric tool in its original
packaging.
The reprinting or reproduction by any other
means, in whole or in part, of documentation
and papers accompanying the products is
strictly subject to the express consent of Einhell
Germany AG.
Subject to technical changes.
- 15 -
26.11.2024 10:04:23 26.11.2024 10:04:23