Servicing The Spark Plug - Toro Titan Max 60In Mode D'emploi

Engine-Oil Service (continued)
6. Slowly pour approximately 80% of the specified oil into the filler tube and slowly add the
additional oil to bring it to the Full mark.
7. Dispose of the used oil per local regulations.

Servicing the Spark Plug

Ensure that the air gap between the center and side electrodes is correct before installing
the spark plug. Use a spark plug wrench for removing and installing the spark plug and a
gapping tool or feeler gauge to check and adjust the air gap. Install a new spark plug if
necessary.
Type: Champion® XC12YC
Air gap: 0.76 mm (0.03 inch)
Removing the Spark Plug
1. Park the machine on a level surface, disengage the blade-control switch, and move the
motion-control levers outward to the P
2. Shut off the engine, remove the key, and wait for all moving parts to stop before leaving
the operating position.
Maintenance: Engine Maintenance
G027477s
G365790s
position.
ARK
Page 5–9 3474-300 A