Inventum IKA8035 Manuel D'utilisation page 44

Problem
The operation indicator on the
control panel of the induction hob
shows Lo.
The display on the control panel of
the hood shows FC.
Some pans make crackling or
clicking noises
The appliance makes a low
humming noise when used on a high
heat setting.
Fan noise coming from the
appliance.
The extraction performance of the
hood has decreased.
The hood continues to run even
though the cooking zones are
switched off.
The glass panel is scratched.
BREAKDOWN CODES
The breakdown codes are shown on the indicators on the control panel.
Breakdown code
EL / EH
C1 / C2
b3
44 • English
Possible cause
There is an empty pan on a cooking
zone and the bottom is overheated.
The child lock is activated.
The longlife carbon filters are worn.
This may be caused by the
construction of the cookware (layers
of different materials vibrating
differently).
This is caused by the technology of
induction cooking.
A cooling fan is built into your
appliance to prevent the electronics
from overheating. It may continue
to run even after the appliance is
turned off.
The grease filter is extremely dirty.
The carbon filter/ longlife carbon filter
is extremely dirty.
There is an object or a lot of water in
the cavity.
The automatic shut-off timer is set.
Pans can have rough edges or
an unsuitable, abrasive cleaning
product or brush is used.
Possible cause
There is a defect in the mains supply.
The appliance is overheated.
The current of the hood driver board is
abnormal.
Possible solution
Remove the pan from the cooking
zone.
Deactivate the child lock. Refer to
section Locking and unlocking the
appliance
.
1. Replace the longlife carbon
filters. Refer to section
and replacing the longlife carbon
filters
.
2. Reset the alarm. Refer to
Resetting the saturation
section
indicator
.
This is normal for cookware and
does not indicate a fault. Make sure
to use good cookware suitable for an
induction appliance.
This is normal, but the noise should
quiet down or disappear completely
when you lower the power level.
This is normal and needs no action.
Do not disconnect the power at the
wall socket while the fan is running.
Clean the grease filter.
Replace the regular carbon filters
or clean the longlife carbon filters.
Cleaning and
Refer to section
replacing the longlife carbon filters
Remove the object and/or clean the
Cleaning the
cavity. Refer to section
cavity and drainage
.
Wait until the hood switches off
automatically. Refer to section
the automatic shut-off mode of the
hood
.
Use pans with a flat, smooth bottom.
Refer to section Requirements for
pans Daily cleaning
and
Possible solution
Do a check on the voltage of the
mains supply.
Let the appliance cool down before
restarting it.
Touch the on/off button to restart the
unit.
Cleaning
.
Using
.