Inventum IKA8035 Manuel D'utilisation page 34

CONTROL PANEL
(Figure 2)
A Slider
B Boost button
C Operation and timer indicator
D Timer controls
E Automatic synchronization button
F Operation indicator
Item
Slider
Boost button
Operation and timer indicator
Timer controls + and -
Automatic synchronization button for the hood
Operation indicator
Bridge zone button
Child lock button
On/off button
Boost button for the hood
Manual control button for the hood
WORKING PRINCIPLE OF THE HOOD
The extraction part of the appliance is used for handling the air of cooking fumes.
The appliance can be installed in two different ways.
Extracting
The cooking fumes are extracted outside.
Warning:
Never connect the pipe to a duct that contains gas or other fuels.
Recirculation
The cooking fumes go through carbon filters, longlife carbon filters or a plasma filter. The filter purifies the fumes and
recirculates these back to the kitchen.
A good outflow of the air is necessary.
Extra information
• Note:
New houses in the Netherlands may no longer vent outside.
• For recirculation, it is necessary to use carbon filters, longlife carbon filters or a plasma filter. For more
information on the differences between regular carbon, longlife carbon and plasma filters go to the website
www.inventum.eu.
• Attention:
Longlife carbon filters should be replaced every five years.
34 • English
G Bridge zone button
H Child lock button
I On/off button
J Boost button for the hood
K Manual control button for the hood
Function
To increase or decrease the power level.
To activate the boost mode.
To show the set power level or the set time.
To set the cooking timer.
To activate the automatic synchronization of the hood.
To show the speed of the cooker hood.
To connect the two cooking zones to one large cooking
zone.
To lock or unlock the control panel.
To start or stop the appliance.
To activate the boost mode of the hood.
To activate and setting the speed of the extraction.