Entering Commands - KERN and SOHN ABS 80-4 Mode D'emploi

7.5

Entering commands

If the balance is connected to a personal computer or printer, the following commands
are available.
See Chapter 7.4, "Formatting input and output data"
If errors not appearing here are transmitted to the balance, proper balance operation is
not guaranteed. In this case, unplug the balance from the power outlet for 10 seconds.
Command code
D01 Continuous printing
D05 Single transmission of data
D06 Automatic output at printer
D07 Single output of data with
stability information
D08 Single output of data with
stability status
D09 Output stop
Q ON/OFF
T Tare
TS Wait for stable tare
CAL Setting
R Restart
46
Function
Weighing
continuously (every 230 ms).
Identical to PRINT key
See the respective settings in AUTO
PRINT.
The
S: If stability indicator is displayed
U: If adjusted without stability
Data output after transmission of
command
AUTO PRINT finishes and the
output
Standby and weighing status
See the respective settings in TARE
key.
Tare is performed after standby.
Reset
Content
data are
data are issued
ABS/ABJ-BA-e-0916
issued
with