Formatting Input And Output Data - KERN and SOHN ABS 80-4 Mode D'emploi

7.4

Formatting input and output data

In the following description, [u] means a blank character and [DL] the end of the
command.
Input data
[COMMAND CODE] + [DL]
See Chapter 7.5, "Entering commands"
Output data
•
With measurement display:
S-200.0000 g u [DL]
Polarity
Stability information
Available with stability display and information
•
The display will indicate oL or –oL,
U- uuu oL uuu [DL]
Polarity
Stability information
Available with stability display and information
ABS/ABJ-BA-e-0916
positive....... Blank character ( u )
negative...... Menus ( - )
stable .......... S
unstable ...... U
positive....... Blank character ( u )
negative...... Menus ( - )
stable .......... S
unstable ...... U
45