KERN and SOHN ABS 80-4 Mode D'emploi page 71

4.3 Menu call
ABS/ABJ-BA-e-0916
Perform the modification test once. Change the "Auto-Zero"
function to OFF and then to ON.
- Turn the balance on by using the ON/OFF/ESC key.
- Press the CAL/MENU key until FUnC.SEL appears.
- Press the TARE/
- Press the CAL/MENU key once until trC :on appears.
- Press the TARE/
The "Auto-Zero" function is selected.
The standby indicator indicates the setting of the
current display.
- Press the CAL/MENU key.
This means:
trC :oF Auto-Zero is off.
trC :on Auto-Zero is on
Select trC :oF
- Press the TARE/
A colon appears when the change is stored.
- Press the ON/OFF/ESC key.
To exit the menu, press the ON/OFF/ESC key at least
2 sec.
Note:
If you wish to store several settings simultaneously on the
operating menu, you do not need to exit the menu each
time. Several settings can be set up before exiting the
menu.
key only once until CAL appears.
-
key once.
-
key once.
19