Publicité
®
KUDO
MULTI-MODE WST
Rigging Procedures
VERSION 1.0
®
12. On each KUDO
enclosure, remove the dolly board by pulling on the captive BLP lanyards.
13. a. Slightly raise the stack and place one support base in position.
b. Use the base-supported KJACK to raise the stack and facilitate the placement of the second support base.
Figure 30: Placing the KJACK support bases in position
KUDO_RM_ML_1.0
All manuals and user guides at all-guides.com
®
SYSTEM
Figure 29: Pulling on the captive BLP lanyards
w w w . l - a c o u s t i c s . c o m
22 en
Publicité
