Publicité
4.2
START THE PRODUCT
Note : The product should be connected to a power
supply. A considerable voltage drop will cause a loss
of power and the motor will be overheated.
CAUTION
Before you start the product:
1.
Turn the water supply on.
2.
Pull the spray gun trigger to release air
pressure.
3.
If a stable stream of water come into view,
release the spray gun trigger.
CAUTION
DO NOT start the product without the water supply
connected and turned on.
1.
Connect the electrical power with plug to a
suitable outlet.
2.
Set the power switch to the "ON" ( | ) position.
3.
Turn the water supply on.
4.
Push the trigger safety latch up and pull the spray
gun trigger to start the spray gun.
English
4.3
STOP THE PRODUCT
1.
Release the spray gun trigger.
2.
Set the power switch to the "OFF" (O) position.
3.
Turn the water supply off.
4.
Pull the spray gun trigger to release the
remaining pressure from the product.
5.
Pull the trigger safety lockout down until it clicks
into the slot.
6.
Disconnect the power cord from the outlet.
Note: If you do not use the product, point the spray
gun in a safe direction, and squeeze the trigger to
relieve built up pressure in the product.
4.4
INSTALL THE SOAP APPLICATOR
Do not use household detergents, acids, alkalines,
bleaches, solvents, flammable material, or industrial
grade solutions, which can do damage to the pump.
Do the instructions on the solution bottle to prepare
detergent.
Note: If it is necessary, use a funnel to prevent the spill
of detergent. Clean and dry the spilled detergent when
you fill it.
9
WARNING
WARNING
EN
Publicité
