Publicité
EN
1.
Put the detergent into the soap applicator.
2.
Install the soap applicator onto the gun and
tighten by hand.
Note: Do not let detergent dry on the surface to
prevent streaks.
5
MAINTENANCE
Before maintenance, make sure that you
• Stop the product.
• Wait until all the moving parts stop.
• Disconnect the plug from the power source.
Do not use strong solvents or detergents on the
plastic housing or components.
Do not let brake fluids, gasoline, petroleum-based
materials touch the plastic parts. Chemicals can
cause damage to the plastic, and make the plastic
unserviceable.
500ml
400ml
300ml
200ml
100ml
500ml
400ml
300ml
200ml
100ml
WARNING
WARNING
WARNING
English
Replace the power cord by an approved service
center.
5.1
PROTECT THE PUMP
• Regular use of pump protector (not included) can
prolong the life of the product by removing hard
water mineral deposits, lubricating pump seals and
pistons, and preventing freeze damage.
• To maintain the best performance from the product,
pump protector should be added to the product after
every use and before long term storage.
Note: The following steps are typical for adding pump
protector to the product. Always read the specific
instructions provided by the manufacturer of the pump
protector used before starting.
1.
Turn the water tap off and set the ON/OFF switch
to OFF.
2.
Press the trigger for approximately 1 minute or
until no more water escapes from the connected
accessory.
3.
Disconnect the power cord with plug from the
outlet.
4.
Disconnect the hose from the water inlet.
5.
Remove the lid from pump protector bottle and
then insert the pump protector bottle into the
water inlet.
6.
Tighten the water inlet sleeve by hand to secure
the connection.
7.
Squeeze the pump protector bottle to inject
protector fluid into product.
8.
The product is protected when the protector fluid
exits the water outlet.
10
WARNING
Publicité
