Publicité
3
INSTALLATION
3.1
UNPACK THE PRODUCT
WARNING
Make sure that you correctly assemble the product
before use.
WARNING
• If parts of the product are damaged, do not use
the product.
• If parts are missing, do not operate the product.
• If parts are damaged or missing, contact the
service center.
1.
Open the package.
2.
Read the documentation provided in the box.
3.
Remove all the unassembled parts from the box.
4.
Remove the product from the box.
5.
Discard the box and packing material in
compliance with local regulations.
WARNING
For your personal safety, do not insert battery before
the product is assembled completely.
3.2
INSTALL THE HIGH PRESSURE HOSE
1.
Uncoil the high pressure hose and attach the end
of the high pressure hose to the base of spray
gun. Tighten by hand.
2.
Attach the other end of the high pressure hose to
the water outlet. Tighten by hand.
English
3.3
CONNECT THE WATER SUPPLY TO THE
PRODUCT
For easy operation, please use a self-coiling garden
hose (not provided).
When you operate the self-coiling hose, make sure
that the hose has no blockage.
• The water supply must come from the water main.
• Do not use hot water.
• Do not use water from ponds or lakes.
Do the local regulations when you connect the
garden hose to the water supply. Direct connection
through a receiver tank or backflow preventer is
usually permitted.
Inspect the filter in the water inlet connector before
you connect the garden hose
• If the filter is damaged, do not use the product
until the filter is replaced.
• If the filter is dirty, clean the filter.
1.
Uncoil the garden hose.
2.
Let the water flow through the garden hose for 30
seconds.
3.
Turn the water supply off.
4.
Install and tighten the end of the garden hose to
the water inlet connector.
There must be a minimum of 3 m of free hose
between the water inlet and the water supply.
3.4
INSTALL THE SPRAY WAND
1.
Push the end of the spray wand into the spray
gun handle.
7
WARNING
WARNING
WARNING
CAUTION
CAUTION
EN
Publicité
