Weighing With User Symbol (Avatar); Connecting The Scale With Your Iphone, Ipod Touch Or Ipad - Medisana TargetScale Mode D'emploi

4.6 Weighing with user symbol (Avatar) without iPhone, iPod touch or iPad
After input of your personal data as described in chapter „4.5 Programming personal
data", you can start to measure your body values without connecting an Apple item.
1. Make sure, the scales are placed on a firm and level surface.
2. Press the - button with your foot or your hand.
3. Step onto the scales and stand still. The device automatically recognizes the actual
user (automatic recognition) and assigns the corresponding avatar
It may be possible, that the automatic recognition selects multiple persons, e.g. if
father and son are having similar body compositions. Therefore make sure, that your
personal corresponding user symbol is shown in the display. If you don't want to
assign an avatar resp. user symbol for the weight data, select the symbol
4. After the initial light sequence your weight and body analysis values will be shown
6
in the display
shows you the distance to your target weight.
The further the lighted circle is away from the center, the more your target weight
is apart from the real (measured) weight (inner circle = up to 1 kg, middle circle >
1 kg to 5 kg, outer circle > 5 kg).
5. Step down from the scales. The scales switch off automatically after 5 seconds.
Measurement values, which are stored in the memory of the scales,
cannot be taken over to an Apple unit later on.

4.7 Connecting the scale with your iPhone, iPod touch or iPad

For using the TargetScale
iPod touch or iPad you need to activate Bluetooth.
A change of the selection may be initiated and confirmed with
the help of your feet.
Lift the left foot:
The next user symbol will be selected.
Lift the right foot:
Confirms the selection.
of the device. Additionally the circles will be lighted up
Body Analysis Scale with target function
Therefore proceed as follows:
1. Press and hold the
until the heart beats (pulsating lights of the circles) get
visible.
2. Start the Apple unit. Touch onto the symbol „Settings"
to open the settings display.
Please pay attention, that the Bluetooth function
is only activated on the Apple unit with which you
want the scale to be connected. If other devices
also have Bluetooth activated, this may cause
bad connections.
4 Getting started
8
and memory.
with your iPhone,
- b utton for at least five seconds,
G
G
. G
7
, what
G
G
G
G
14
GB