Getting Started; Insert / Replace Batteries; Calibration Of The Scales - Medisana TargetScale Mode D'emploi

Balance-impédancemètre avec fonction objectif de poids
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 60

4 Getting started

4.1 Insert / replace batteries

Before you start up your scale, insert the four provided 1,5V batteries (type AA) into the
device. To do this, open the battery compartment
batteries. Make sure the polarity is correct (as shown in the battery compartment).
Put the lid of the battery compartment back on and push it until it clicks into place.
Change the batteries when the battery change symbol
or when nothing is shown in the display after the device is switched on.
WARNING
• Do not disassemble batteries!
• Clean the battery and item contact points before inserting the batteries if
necessary!
• Remove discharged batteries from the device immediately!
• Increased risk of leakage, avoid contact with skin, eyes and mucous mem-
branes! If battery acid comes in contact with any of this parts, rinse the affected
area with copious amounts of fresh water and seek medical attention
immediately!
• If a battery has been swallowed seek medical attention immediately!
• Replace all of the batteries simultaneously!
• Only replace with batteries of the same type, never use different types of
batteries together or used batteries with new ones!
• Insert the batteries correctly, observing the polarity!
• Remove the batteries from the device if it is not going to be used for an ex-
tended period!
• Keep batteries out of children's reach!
• Do not attempt to recharge these batteries! There is a danger of explosion!
• Do not short circuit! There is a danger of explosion!
• Do not throw into a fire! There is a danger of explosion!
• Only store unused batteries in the original packing and not in reach of
metallic items in order to avoid short circuit!
• Do not throw used batteries into the household refuse; put them in a hazardous
waste container or take them to a battery collection point, at the shop where
they were purchased!

4.2 Calibration of the scales

If this symbol
attention, that the scales are placed on a solid and even ground.
During the calibration process, the scales must not be loaded with any weight. If the
location of the scales is changed, a new calibration is necessary. Therefore switch the
scales on and off once.
4.3 Change the unit of measure
1.
Turn the scales and open the battery compartment
2.
Use the switch inside the compartment to choose the preferred unit of measure (kg -
lb - st).
11
GB
BATTERY SAFETY INFORMATION
appears, the automatic calibration of the scales is active. Pay
2
beneath the device and insert the
appears in the display
2
.
G
G
6
G
E
G
G

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

40417

Table des Matières