Weight Only / "Step-On"-Function; Programming Personal Data - Medisana TargetScale Mode D'emploi

4.4 Weight only / "Step-on"-function
1. If the location of the scales is changed, a new calibration is necessary (see 4.2).
2. Make sure, the scales are placed on a firm and level surface.
3. Step onto the scales and stand still. The device switches on automatically.
After the rings lit up, your weight is displayed in the display of the scales.
4.
5. Step down from the scales. The scales switch off automatically after 5 seconds.

4.5 Programming personal data

The scales can store data for up to 4 persons: Target weight, height, age, gender and
fitness grade. These data are stored in 4 user memories, which are represented by
a specific user symbol (avatar)
male, 30 years old, 175 cm, non-athletic.
1. Press the ON-button
2. The identification (iD) for the user symbol selection mode (avatar-
mode) appears in the display
select a user symbol.
3. Please choose one of the 4 different symbols (avatars).
4. Confirm the selection with the OK - button
5. Choose, if you want to input a target weight value or not. If you want to
choose to input a target weight, the scales will calculate the difference
to your measured weight for any future measurement and will show
this difference in the display and additionally with the flashing circles.
6. Your selection will be shown for 2 seconds.
7. If you have selected to input a target weight, you will now be asked
to input this target weight. You may input a weight, which you want to
reach. You can control your weight development and your success
by using this feature.
Use the + - and - - buttons
confirm the selection with the OK-button
8
. The scales have preset values. These are:
1
.
6
. Use the + - and - - buttons
4
to input your selected target weight and
4 Getting started
4
5
.
5
.
G
G
G
G
G
G
G
to G
G
G
G
G
G
G
12
GB